A jig I made for grinding better bevels
The two bolts on the bottom go through the angle iron and tilt the jig to whatever angle I need to grind a bevel.
I haven't tried it yet cause I need to increase the table length on my belt sander to 20 inches. I have a 20 x 5 x 3/8 plate I will use. Its on the thick side so its very heavy.
This will allow me to drag the jig along the plate.
Here is an example of how it will work
The only downside of my jig is that its so big it forces me to use a big table. But it will be a lot more stable then a smaller one like in this picture ....I hope
No comments:
Post a Comment